CDS Services
SERVICES VARY BASED ON LOCATION
INDUSTRY-LEADING DIESEL SOLUTIONS AT
CDS UTAH
CDS Utah, locally known as J Mac Radiator, provides trusted DPF cleaning and emissions system solutions in Salt Lake City, UT. As a Cummins-approved affiliate of Clean Diesel Specialists, Inc., CDS Utah delivers reliable, high-quality service using certified equipment and proven processes to ensure compliance and optimal diesel engine performance.
ALL SERVICES AVAILABLE AT CDS Utah:
Thermal-Aqueous Cleaning with over 96% recovery of filters serviced
Cleaning practices designed to extend filter life
Restoration of fluid-compromised filters
Minor repairs on restorable filters
Convenient pick-up and delivery services
24-hour turnaround on cleaning services
Filter Service Process:
Pre- and post-cleaning inspection, diagnosis, and documentation
Filters weighed and airflow measured
Pin testing for filter integrity
Cleaning performed according to CDS protocols
Filters restored to “like new” condition
Meticulous detailing of all filters
Additional Services:
DOC, SCR, and EGR cleaning
Aftermarket replacement filters and parts
Clamps, gaskets, and bungs available
R&R (Repair and Replace): Comprehensive service to remove components from the truck, repair or restore them to optimal condition, and reinstall securely, ensuring reliable operation.
SERVICING THE
SURROUNDING AREA:
South Salt Lake, UT
Millcreek, UT
Murray, UT
West Valley City, UT
Taylorsville, UT
Holladay, UT
Cottonwood Heights, UT
West Jordan, UT
Sandy, UT
Draper, UT
Bountiful, UT
North Salt Lake, UT
Midvale, UT
Kearns, UT
Riverton, UT
ADDITIONAL DPF CLEANING
Solutions & Benefits

ENSURING OPTIMAL PERFORMANCE WITH
our 8-Step DPF Cleaning Process
STEP 1
Initial
Inspection
We thoroughly inspect each filter for signs of external damage, contamination, and wear, identifying any issues that might affect performance.
STEP 5
Eliminate Moisture & Dry
The filter is dried to eliminate any residual moisture, preventing interference with the thermal regeneration phase.
STEP 2
Record & Document
We record initial airflow, weight, and condition to create a baseline, ensuring clear tracking of improvements throughout the cleaning process.
STEP 6
Thermal
Regeneration
The filter is heat-treated at controlled temperatures to burn off remaining fine particulates, ensuring thorough decontamination.
STEP 3
Blast
Cleaning
Using high-pressure compressed air, we carefully dislodge large soot and ash particles from the filter, preparing it for deeper cleaning.
STEP 7
Cooling &
Final Check
After cooling, we perform a final airflow test and structural check to confirm that the filter meets performance standards.
STEP 4
Aqueous
Cleaning
The filter undergoes a high-pressure water cleaning, reaching deep into the filter substrate to remove smaller particles that air-blasting alone may miss.
STEP 8
Package & Transport
The cleaned filter is securely sealed and labeled for safe transport, along with detailed documentation of the cleaning results.
Parts & Products
AVAILABLE AT
CDS UTAH
No Parts Available at this Time
Product | Part Number | Dimensions | Make | Model | Type | Additional Info |
---|